Security & Surveillance Equipment Enclosures

CCTV Housing designed for system integrators, security equipment manufacturers and infrastructure contractors,  can accommodate PoE switches, power supplies, fiber equipment, routers and other field devices. We manufacture from customer-approved drawings or optimize enclosure details around the equipment layout, installation method and outdoor environment.

One Project, Two Mounting Methods

Surveillance equipment may need to be installed on both walls and poles. Separate enclosure designs increase product variants, while field drilling or welding may damage the coating and compromise the original weatherproof structure.

GX-BOX Solution：A common enclosure body can use reinforced rear interfaces with dedicated wall or pole mounting components. The installation method can be changed without modifying the main enclosure, internal equipment layout or protected cable-entry structure.

Outdoor Coating Failure Begins with Poor Surface Preparation

Cut edges, welded joints, ground areas and bends may become the first points of coating failure on an outdoor enclosure. Exposed aluminum can oxidize, while galvanized steel may develop red rust once the powder layer and local zinc protection are no longer sufficient.

GX-BOX Solution：Surface treatment is matched to the base material. Aluminum is mechanically roughened before powder coating to improve the bonding profile. Galvanized steel enclosures undergo pickling and phosphating pretreatment after fabrication, with special attention to cut edges, welds and bends. Electrostatic powder coating then forms the outer protective barrier, creating a layered system for improved coating adhesion and outdoor corrosion resistance.

Aluminum Welding Must Preserve Strength and Environmental Sealing

Aluminum is lightweight and helps spread heat from continuously operating surveillance equipment, but thin aluminum sheet is difficult to weld consistently. It conducts heat away from the weld quickly while melting at a relatively low temperature. Too little heat can cause incomplete fusion, while excessive heat can rapidly lead to burn-through, holes or cabinet distortion.

GX-BOX Solution：We uses experienced aluminum welders, controlled argon-arc welding, fixture positioning and planned welding sequences to manage heat input and distortion. Load-bearing areas are reinforced around the equipment layout, while weld continuity, cabinet squareness, door-frame flatness and door gaps are checked before final grinding and finishing. This preserves the weight and heat-spreading advantages of aluminum without sacrificing structural strength or sealing stability.

Which Enclosure Box Do You Need?

• 

  outdoor pole mount enclosure

• 

  Aluminum Equipment Cabinet

• 

  CCTV control box

• 

  pole mount rack enclosure